# 2. Software Architecture¶

This section describes the foxBMS software architecture. The architecture was chosen to enable a processor independent programming as far as possible. Fig. Fig. 2.27 shows the software architecture of foxBMS.

The software consists of a base hardware abstraction layer of the microcontroller. The driver layer on top if it is used to configure and initialize the peripherals of the microcontroller. These hardware dependent layers resemble the base of the software architecture. The remaining modules are built on top of it to allow an easy port of the software to different microcontrollers.

## 2.1. Hardware abstraction layer¶

The hardware abstraction layer (HAL) consists of the STM32F4xx HAL Drivers V1.5.0. Additionaly the Cortex Microcontroller Software Interface Standard (CMSIS) V2.5.6 is used as an abstraction layer for the Cortex M4F processor.

## 2.2. Drivers¶

The driver layer is responsible for the configuration and the initialization of the controller peripherals. These drivers are dependent on the specific used microcontroller and the used HAL. Drivers are only allowed to include files from driver or the lower hardware abstraction layer (i.e. SPI modules includes DMA module to configure the respective DMA stream).

## 2.3. foxBMS-Modules¶

foxBMS-modules initialize, configure and control hardware connected to the foxBMS Master Unit. These modules are only allowed to access the hardware through the drivers and directly via the HAL. No direct function calls to the HAL should be make the modules as independent as possible from the used microcontroller. They may include engine modules (i.e. database, diag), applications (com) or even the operating system if they need to ensure some runtime specific behaviour. These modules are called within the operating system to ensure a real-time behaviour.

## 2.4. Operating System¶

The real-time operating system FreeRTOS V9.0.0 is used to manage the foxBMS-engine and applications. Tasks with different priorities are used to process the different algorithms and state machines and to ensure a real-time behaviour of the different modules.

## 2.5. foxBMS-Engine¶

Important hardware independent software modules are bundled to the foxBMS-engine. This involves a database for storing important parameters, a diagnosis module for error detection and handling as well as the startup/initialization behaviour of the BMS. The operating system engine tasks are the tasks with the highest priorites and used to ensure a real-time behaviour of the safety-critical modules. Engine modules are allowed to include foxBMS-Modules, drivers, applications and of course the operating system.

## 2.6. foxBMS-Application¶

The application layer gathers all hardware independent modules that are responsible for the actual BMS functionality (i.e. SOC, SOH, balancing…). The most important module is the bms module that monitors the behaviour of the battery system to ensure an adherence of the safe-operating area and controls the BMS state (i.e. charging/discharging). The operating system applications tasks are the tasks with the lowest priorites to ensure a real-time behaviour of the safety-critical modules. Applications are allowed to include foxBMS-Modules, drivers, engine-modules and of course the operating system.